Time-cert on drain plug hole.

6 replies to this topic
  • four2sixxer

Posted April 18, 2011 - 02:37 PM


Im time certing it today and wanted to know what would be good to flush through the bike to get the shavings that might get up in the case. Thanks!

  • dirtdevil72

Posted April 18, 2011 - 02:41 PM


Brake cleaner

  • moto2000

Posted April 18, 2011 - 03:07 PM


A little compressed air in the case vent will help prevent shavings from getting in your motor while drilling or tapping.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed

Posted April 18, 2011 - 04:18 PM


Dip the tap and drill bit in a thick grease. Most of the shavings will stick to the grease.Drill at a slower speed so not to sling the grease. Or you can have someone hold a shop vac hose next to where you are drilling as well.


  • four2sixxer

Posted April 18, 2011 - 05:23 PM


Ok, thanks guys I was going to dip the tap as well. I might run some cheap oil through it as well

  • yz450fcranker

Posted April 22, 2011 - 01:43 AM


four2sixxer can you post pictures

  • four2sixxer

Posted April 25, 2011 - 08:53 PM


Yea I will when I start the job ive been busy lately so no time and I dont wanna rush this and mess it up so im going to do it on a stress free day.

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.