06+ YZ lighting


No replies to this topic
  • sledtrash

Posted April 11, 2011 - 07:35 PM

#1

So I just got down installing a WR crank and lighting system to achieve lighting capabilities... and I had an epiphany... the 10' YZ450 has FI and I read somewheres on the forum that it has more output than a WR. So I was wondering if anyone out there has a 06-08 model and a 10' model and could compare magneto shaft sizes. I'm wondering if the 10' flywheel could be the same size and be thrown on the 06' model crank and then purchase a WR flywheel cover and put the stator in it.

If it is the same with a little wiring knowledge a person might be able to come up with a wiring solution for a YZ without having to run off of a batt, or tearing your engine apart.

Just me :cheers: again :ride:





Related Content

Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
Forums
Photo

05 yz450f not fast enough by RedeyeYZ


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.