Please Help : Magura clutch on YZ450 06


No replies to this topic
  • Bennyyz450f

Posted February 18, 2011 - 07:38 PM

#1

Hi guys i am hoping someone can help i just bought a magura clutch for my 06 YZ450 and i have got it all installed and the slave cylinder slipped right into the original clutch bracket on the engine but when i pull the lever it just does'nt engage the clutch roughly only halfway. i have put the washer spacer in and it is not much better. On the instructions it says to pull the slave cylinder out and if it is more than 4 mm gap then you have to put more spacers in but when i pull mine out it comes out about 12-14mm and if i put spacers on that the cylinder wont snug into the clutch bracket

Any Ideas anyone please or if you have had the same problem how did you fix it

Thanks.





Related Content

Reviews

Yamaha YZ450F 2017 by Chris.GVS


Yamaha YZ450F 2017
  • - - - - -
  • 0 reviews
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Megabomb Fitment by 288yz450


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.