YZ426 Catastrophic Failure


22 replies to this topic
  • MNellis

Posted April 11, 2011 - 05:55 PM

#21

That's all cool, except that the spec for intakes is .10-.15mm. Typo?


Yes, that was a typo but my manual shows .15mm - .20mm as the intake spec. Thanks for the catch and also for all the help you've provided on the forum over the years.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted April 11, 2011 - 08:37 PM

#22

2000 with SS valves, then, right?

  • MNellis

Posted April 12, 2011 - 11:26 AM

#23

2000 with SS valves, then, right?


Yup, 2000 and I'm assuming the valves are probably SS. All the intakes were replaced right after I bought the bike (used) a failure caused the piston and valves to get more acquainted with each other than they should have. That's a whole other rebuild story.

Posted Image





Related Content

Forums
Photo
Supercross

Wilson the Blue Privateer by jetfuel


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

BIGBORE FOR YZ450F 2006? by Taattie94


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.