flywheel puller question

2 replies to this topic
  • brentn

Posted January 11, 2011 - 12:43 PM


I have a flywheel puller from moose racing that worked on my old 05 250 two stroke. I used it in conjunction with my clutch holding tool that had two little pins on the opposite side meant to hold a flywheel.

Will these tools work on my 2010 450 or will I have to buy a new flywheel puller/holder?

Just curious, I'm sure there will be work down the road on this bike just want to be prepared.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted January 11, 2011 - 01:09 PM


Neither will work (although the clutch holder may hold the clutch).

The flywheel puller is the same one used on the '06 and later YZ450, and on the CRF450.

To hold the flywheel for the purpose of torquing the nut, all you need is a 19mm open end.

  • brentn

Posted January 11, 2011 - 03:14 PM


Thx for the clarification.
It was only 20$ so another one isn't going to break the bank. Worst thing ever is getting into the engine and halfway through a job when you realize that the tool you thought would work doesn't and everybody is closed :smirk:

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.