'03 stator cover remove/replace

2 replies to this topic
  • Lcpl0331

Posted December 04, 2010 - 06:30 AM


Is this a straight up swap or is there anything I could screw up in there? What should I pay special attention to? I looked around in here a bit but couldn't find anything specific.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • William1

Posted December 04, 2010 - 01:48 PM


Pretty straight forward. Just be careful you do not pinch a wire and that you put the parts on the new cover exactly like they were on the old. Be sure to use Yamabond sealant where the wires pass through.

  • Lcpl0331

Posted December 04, 2010 - 04:04 PM


Thanks was hoping you would respond.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.