I stripped the left crankcase oil drain bolt


3 replies to this topic
  • Ariel101

Posted November 26, 2010 - 11:32 AM

#1

I'm going to buy time-sert and need the bolt size. The manual says M6 x 1.0 (its a 08 WR450-F).

Posted Image

However when measured I get 8 mm width. So what is the correct size?

  • crooks420

Posted November 28, 2010 - 06:08 PM

#2

If youre not sure, try finding a die that the bolt fits.....

Jesse

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Ariel101

Posted November 29, 2010 - 10:38 AM

#3

I finally had to actually measure its size with thread tester. Its M8 x 1.25

  • pwrpapa

Posted December 03, 2010 - 03:12 PM

#4

Is there enough meat to go to a 10mm bolt, if there is than I would do that instead of an insert.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.