shift pin missing


1 reply to this topic
  • dalboy

Posted November 06, 2010 - 07:05 PM

#1

my mates wr400 99 model would not shift out of 1st gear. so we pulled the clutch cover and found the pin holding the shift 2 lever (3XK-18122-00-00) missing. we found the shift lever roller (3XJ-18178-00-00) sitting in the case at the bottom but no pin. is this pin pressed into the part? and when we order a new one do you order the whole part as shown above, or can you order the pin seperately? also where is the pin likely to be? and is it common for it to fall out?

cheers
matt

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • dalboy

Posted November 08, 2010 - 12:08 PM

#2

no one else had this happen to them?




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.