Flywheel removal?


1 reply to this topic
  • adamjv78

Posted October 13, 2010 - 06:59 PM

#1

Hi,

I'm replacing the timing chain on my 02 WR426F, but i can't get the flywheel off. I've bought a flywheel remover, but no matter how much I tighten it, the flywheel won't budge.

Can I damage the internals of the magneto by putting to much preasure on the shaft it sits on?

Just wanted to be sure before I go hell for leather at it.

Cheers.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • William1

Posted October 13, 2010 - 09:03 PM

#2

First, tighten the large section on to the flywheel
Tighten the center bolt
Give the center bolt a sharp rap with a hammer
Tighten the center bolt again
Rap with the hammer, repeat if needed- Pop it comes off




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.