Who has adjusted valves on their WR 450?



1 reply to this topic
  • Lowedog

Posted June 30, 2003 - 06:09 PM

#1

...Or any of the WR/YZ's for that matter. I checked clearance at break in. I am now at 500 miles and figure I should check again (even though the manual says 500km). I am curious if any one has actually had to adjust their valves at this point? Should I stop by the Yamaha shop and get a selection of shims before starting the job?

Thanks in advance for any input,
Lowedog

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Indy_WR450

Posted June 30, 2003 - 06:13 PM

#2

Yeah I had to do mine at 2000 miles a few weeks ago. I like to keep them on the tight side. They were on the upper end of the tolerance. :)




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.