kick start assemly problem


1 reply to this topic
  • john simonette

Posted August 29, 2010 - 06:33 PM

#1

I was at the track yesterday and noticed that my kick start wasn't flying back into place after starting my 06 yz 450f. I took my kick start arm off by unscrewing its main bolt (Phillips head) and pulling it off so as to lubricate it. My problem is that a ball bearing fell out when I pulled off the kick start arm. I think I know where the ball bearing goes, but I can't put the kick start arm back on with the ball bearing in place. When I went to my manual, it overlooked this. Can anyone share information on how to get my kick start arm back on?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • rjcook450

Posted August 30, 2010 - 03:19 PM

#2

did the same thing to my 08, bearing fell out when i was going to grease it. i just put some grease on bearing and then stuck it the hole it resides in on the back of the kickstart shaft the grease held it there while i slid the kickstarter shaft back on.





Related Content

Forums
Photo

1998 yz400f will not idle. by trolley


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  32 replies
Forums
Photo

BIGBORE FOR YZ450F 2006? by Taattie94


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.