08 yz450 stator?


2 replies to this topic
  • qwert321

Posted August 25, 2010 - 08:56 PM

#1

I had one of the small screws(the four in between the windings in picture) holding staor to plate come out and wreck my stator and flywheel.My question is can I remove these bolts one at a time and locktite them on my new stator and not do any damage to windings.I want to do this as the other three screws where loose also.

Posted Image

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Bigdong

Posted August 26, 2010 - 12:15 PM

#2

I doubt taking one out at a time will loosen the windings. If your worried about that then just use a g-clamp on each side as you unscrew the bolt.

  • qwert321

Posted August 26, 2010 - 05:12 PM

#3

I ended up doing it one screw at at time and the stator still worked so all is good.I dont know why they dont locktite it from factory.$525 dollars because of no locktite, atleast the new stator and flywheel was a upgraded part.





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
Forums
Photo

YZ450F 03 Sparks driving me crazy by SirAttard


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  94 replies
Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.