Tech question


1 reply to this topic
  • dbehr624

Posted June 26, 2010 - 07:59 PM

#1

So not all that long ago, I had a crank bearing go sour on my 06 450, which caused my stator to malfunction. After replacing both, I took the blue beast out to the desert and it was running great. I came back from a ride, and when I went to take off for another, absolutely nothing. No spark. First guess of mine was that maybe my killswitch had a little short in it, but I disconnected that, so I could check that off the list. So I guess that leaves the stator and CDI. Any suggestions as to what may have caused this or where I should look?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • iDuner

Posted June 26, 2010 - 08:13 PM

#2

Do an AC output test on the pulser lead and the leads from the stator.





Related Content

Forums
Photo
Supercross

Wilson the Blue Privateer by jetfuel


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies
Forums
Photo

05 yz450f not fast enough by RedeyeYZ


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.