2009 tps sensor


5 replies to this topic
  • DAVID146

Posted June 08, 2010 - 09:49 AM

#1

I had to remove the TPS to get the carb back in afther piston replacement. I put it back in the same as it came out will have have to adjust it like the manual says? or will it have no effect?

  • grayracer513

Posted June 08, 2010 - 10:06 AM

#2

Yes, you will have to at least check the adjustment with a volt meter as the manual shows, and more than likely have to adjust it. I'm not sure how you managed to re-install the TPS with the carb in place, but you normally need to remove the carb in order to even reposition it for an adjustment.

It should not have been necessary to dismount it in any case, and for future reference, the best approach is to remove the sub frame and rear shock for access to remove the carb. Doesn't really take as long as it sounds.

  • mkporn

Posted June 08, 2010 - 11:11 AM

#3

Yes, you will have to at least check the adjustment with a volt meter as the manual shows, and more than likely have to adjust it. I'm not sure how you managed to re-install the TPS with the carb in place, but you normally need to remove the carb in order to even reposition it for an adjustment.

It should not have been necessary to dismount it in any case, and for future reference, the best approach is to remove the sub frame and rear shock for access to remove the carb. Doesn't really take as long as it sounds.


I will second that ^^^^.. Takes about 5 minutes max to pull the sub, exhaust and shock. 7 or 8 bolts and a clamp and everything is out of the way.... even makes doing that motor work ten times easier.:thumbsup:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • etug321

Posted June 08, 2010 - 05:56 PM

#4

Isn't there a wire harness that you can unplug. I went through this once and it wasn't fun.

  • DAVID146

Posted June 08, 2010 - 06:49 PM

#5

So if I read it right. at idle check the volt on the correct wires and adjust untill I get the right volt?

Thanks

  • grayracer513

Posted June 08, 2010 - 07:09 PM

#6

Yup, that's it.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.