Cycra Probends and grips?


No replies to this topic
  • Stroker06

Posted April 13, 2010 - 09:16 PM

#1

Hey guys! Thanks to all your recommendations I purchased a set of Windam Mx/RM mid Pro-taper Contour bars for my 6'4" self. They should be here Thursday.
My question is a, duh why didn't I think of that kind of thing, but after getting the bars and some new grips. What methods did you all use to install handguards through the grip.
My stockers I just used a utility knife for the throttle tube and grip, but afterwards wished I had done something a little cleaner. Now I have the opprotunity to do it right and would like some opinions/options for putting a hole in the end of the grip.
I would like to keep the ridge on the end to maximize the amount of grip (read: wide fat hands) and can't afford to lose any. So the best method for just putting a hole in there is what I am looking for.
Thanks again for the advice on the bars and I will let you know how it all works.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.