YZ250F Jetting that works(it starts)!!



No replies to this topic
  • jimt_yz400

Posted December 23, 2000 - 05:54 PM

#1

Over the last few weeks I've seen posts relating to the YZ250F and it's starting pblms. I think that I may have figured this
beast out. I can start this this wonderful
machine on the 2nd kick EVER time, warm or cold (if it is warm I need to use the hot start if it will not light-up in two kicks).

I've richened the main up so that it pulls VERY well and does not go FLAT at the higher
RPM's and I've leaned it out on the bottom with a leaner pilot. The pblm with the bike
not starting well (for me at least) was that
it was too rich in the pilot circuit.
The bike is VERY responsive on the bottom and
pulls much better and is very crisp off of idle.
Here is the jetting:
Pilot - 40
Fuel screw - 2 turns out
Needle - Stock (can't remember the number).
Main - 182 (the 180 maybe OK but works well for me).

I'm ride at 100ft to 2000ft above sea level using 92 Octane pump gas.

Hope this helps!!





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.