Stupid fork question


4 replies to this topic
  • i_wheelie_longer

Posted January 31, 2010 - 03:50 PM

#1

I'm going to be replacing my fork seals for the first time in an 06 yz450f and 08 yz250f. I would get a 48mm fork seal driver, right? And I would need a 48mm fork cap removal tool as well, correct?

  • grayracer513

Posted January 31, 2010 - 04:53 PM

#2

The seal driver is 48mm, yes, but the cap/cartridge wrench is an 8 point 49mm. You may also want the base valve removal wrench (32mm 8 point) so you can do a full oil change.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • i_wheelie_longer

Posted January 31, 2010 - 08:47 PM

#3

thanks for your help

  • machalooney

Posted February 01, 2010 - 05:14 AM

#4

fork bullet so you can put the new seals on without chancing tearing the seal.

Part 1 of 3 series. Good to watch first so your are mentally prepared.

  • grayracer513

Posted February 01, 2010 - 08:26 AM

#5

The bullet is a waste of money. The plastic bag the seal comes in works just as well.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.