Fuel screw in no danger of falling out



3 replies to this topic
  • Guest_Guest_*

Posted May 04, 2003 - 07:15 PM

#1

Adjusted my valves yesterday, and decided to install the Zip-ty fuel screw. Problem is I can't get the factory screw to drop out (doing without pulling the carb) tried to grab it with tweezers, no luck. Any idea's :)

  • Littlefoot

Posted May 05, 2003 - 02:59 AM

#2

The fuel screw on my '99 also will not drop out. You must remove the fuel bowl to get it out.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Chas_M

Posted May 05, 2003 - 08:20 PM

#3

You need to remove the float bowl and carefully drill out the fuel screw hole in the float bowl so that new fuel screw just barely fits through opening. Be careful not to lose spring, o-ring, and small washer at tip of fuel screw. Before drilling, check to see if new fuel screw will fit through original hole.

  • Guest_Guest_*

Posted May 06, 2003 - 04:59 AM

#4

Thanks I'll wait till I need to service the carb. The bikes running perfect now. :)




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.