Water Pump Shaft and Seals


1 reply to this topic
  • BUDDO

Posted November 06, 2009 - 11:33 AM

#1

05 WR450
I am going to replace the shaft and seals on my water pump. Does anyone know the step by step on this process? Does it go over this in the manual? Any help would be greatly appreciated.

Thanks

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • klossWR450

Posted November 07, 2009 - 01:19 PM

#2

haven't got a step by step but this is an easy job, you have to remove the pump cover obviously, undo all right side cover bolts, no need to take off the clutch cover but 2 or 3 bolts holding it are long and reach the cases so will have to be removed too (can't remember but possibly top ones), no need to take the oil filter cover off, once you have the side cover off it's all clear, hold the shaft with a flat spanner and undo the impeller nut, pull it out, push out the seals, fit new ones, GREASE them, fit the shaft etc, just check the orings under the oil filter are all in place before refitting, good luck




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.