Pull arm to do buffer?



4 replies to this topic
  • Guest_Guest_*

Posted April 13, 2003 - 11:56 AM

#1

Time to change the chain buffer on my 99 WR, this will be the first. Do you have to remove the swing arm to replace the buffer? I did a search and couldn't find a answer..
Thanks Domenic :D
Never mind I found the information :)

  • ddialogue

Posted April 13, 2003 - 04:18 PM

#2

I would think so. It just doesn't seem like there's enough room between the countershaft sprocket and the swingarm to pull it around.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • WR_Jason

Posted April 14, 2003 - 09:38 AM

#3

Yeah, so whats the answer?

  • MOmilkman

Posted April 14, 2003 - 04:37 PM

#4

Ive replaced the stock chain buffer (no, you do not have to remove the swingarm) and I have put a TM designs buffer on. (yes, you do have to remove the swingarm)

  • Guest_Guest_*

Posted April 14, 2003 - 05:19 PM

#5

The answer is both, I'll pull the swing arm and service the bearings at the same time, I never had this much maintenance on my 2 stroke :)




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.