03 WR450: Messed up crank shaft thread making rotor removal too much fun

No replies to this topic
  • Andrejs2112

Posted September 21, 2009 - 01:52 PM


My flywheel threads are f'd up from the rotor bolts backing out and eating my stator and rotor. The threads got chewed too, so now my rotor removal tool will not thread on. What size die do I need to re-thread ? What other options do I have to pull it off? The rotor is junk so ruining it is not a problem. Should I remove it with a 3 jaw puller?


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.