DMM to DVP



1 reply to this topic
  • bman

Posted August 30, 2002 - 01:06 PM

#1

Just to make Taffy happy. Say if I were going to change my needle from my present settings "see below"
to a dvp, what position would the clip be on? Right now my dmm is on P1. How about a EMN. I have both in my tool box. How about it? Also, what will they do different that my present setup?

DMM=p1
EMN=?
DVP=?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • LarryCO

Posted September 03, 2002 - 09:43 PM

#2

DM_ #1 = DV_ #5...M - N - P - Q - R - S - T - U - V...with each letter change meaning 1/2 clip position.

When trying to convert a "D" series needle (0.75 degree taper) to an "E" series needle (1 degree taper), I subtract about 6 letters to equate the two due to the taper difference...to get the taper start position of both needles to be the same. Thus, EK_ #3 roughly equals DR_ #3.

Larry




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.