how much?



1 reply to this topic
  • eduardo

Posted March 07, 2003 - 07:12 AM

#1

Ok, how much should i cut the accelerator stop screw in the wr426?
I saw one guy talking about 8mm for the wr400 model.
I also read 11mm for the 450 model.
What about the 426? :)

Thanks in advance.
Eduardo

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Indy_WR450

Posted March 07, 2003 - 05:30 PM

#2

Pull the carb out and remove the screw. Turn the spring loaded throttle wheel until the slide just clears the opening. That is the position that the bolt must hit the stop flange on the throttle wheel. Measure the distance through the bolt hole to the flange and cut the bolt appropriately.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.