Rekluse Perch Adjuster on 08 WR450


2 replies to this topic
  • ears2244

Posted May 02, 2009 - 06:02 PM

#1

I have a question about a Rekluse perch adjuster for my 08 WR 450. I cannot figure this out, I ordered the extra cable and have all the right parts but the fit is terrible as in the perch adjuster hangs to the side or the clutch adjuster not tight or anything like the picture. If I loosen it to spec like the rekluse staff says it just seems wrong and at any point can I override the z-start clutch like it is supposed to. The clutch actuator arm on the WR just moves freely when off or on. I know when I'm riding it tightens a little but nothing to major to pull my slack in. Any help would be greatly appreciated.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • gdbarr1976

Posted May 04, 2009 - 01:20 PM

#2

Not sure if this is your problem but for what it is worth I ran a light spring from my clutch arm to the bracket that is where the clutch cable attaches to the engine on the the wr( it is different on the yz).Anyway it just gives a little help to the clutch as in faster engagment and also gives the clutch lever a better feel at the lever.

  • ears2244

Posted May 04, 2009 - 05:57 PM

#3

I never thought of that...Thanks for the tip. I'm gonna try it tomorrow




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.