Coolant Hose Question


2 replies to this topic
  • gator4life108

Posted April 28, 2009 - 04:29 PM

#1

So I ran the bike for like a minute and a half, and all of a sudden water started spewing out of the seal shown below. 1998 YZ 400

I recently did the water pump and installed the seal listed below, is it supposed to be lower down the pipe into the pump? Does this look right?

Posted Image

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • zuch95701

Posted April 28, 2009 - 04:41 PM

#2

its supposed to be much lower all the way down at the bottom of the sleeve.

  • grayracer513

Posted April 28, 2009 - 07:58 PM

#3

There's a ridge on the pipe. The O-ring belongs below it. You have it above the ridge.





Related Content

Forums
Photo

Megabomb Fitment by 288yz450


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
Forums
Photo

First Hare scramble tips by dhend8


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.