Excel universal hubs-bearing removal

2 replies to this topic
  • FinchFan194

Posted March 30, 2009 - 04:02 PM


Never done these before anyone have any experience with em? They are way different than stock the spacers are pressed in and everything. I hope this isn't going to be a PIA!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • KJ790

Posted March 30, 2009 - 04:25 PM


It's not bad, the spacers should just tap out (unless they are really corroded in). Unbolt the carrier rings and then pry the seals out. Other than that they aren't much different than stock wheels, just with bigger bearings. When you put them back together put a little grease on the spacers to make it easy to get them in and out.

  • FinchFan194

Posted March 30, 2009 - 04:27 PM


Thanks for the reply I really appreciate it!

Related Content


Help with 2000 yz426 by weekend woods racer

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  36 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.