Problem with Powerbowl install


No replies to this topic
  • Pilfer8

Posted March 22, 2009 - 09:30 AM

#1

I don't want to get into a debate whether the purchase was worth it or not, but for those of you who already have it, I can't get the diaphragm rod through the hole in the powerbowl. The hole is too small. Being Sunday, I don't think tech support will be around. Anyone had this problem? I was looking forward to getting the bike up and running again today. I am considering just drilling it out, but.....
It's a 2003 YZ450F w/zipty mod if it helps.

Thanks,

Dan

*EDIT - figured it out, it was just some kind of wax or varnish build up in the hole. all is well.





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
Forums
Photo
Motocross

Thinking about Yamaha 250... by Arctic Pride


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.