Temp Correction



1 reply to this topic
  • HaremScarem

Posted August 05, 2002 - 10:54 AM

#1

Gentlemen
I have a 2002 426 wit hthe lid off and uncorked.
Stock jetting. The bike has lost it's snap when cracking the throttle. I think it's because of the High temperatures and Humidity.
The stock jetting is ..
165MJ
42 PJ
DRR 4th clip

I was going to reduce the size of the Main jet to a 160 and raise the clip to the 3rd slot. The as found factory setting on the fuel screw was 2 turns out. I was thinking of reducing this to
1 1/2 turns out.

Please tell me if I'm on the right track or do you guys suggest something else?

Regards

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Hick

Posted August 05, 2002 - 03:02 PM

#2

Just ignore me, because I always say the same thing, and that is:

Uncorked/uncovered WR is pretty much a stock YZ, so why not try YZ jetting (basically a needle change).

I've jetted three WR 426s, and used E tapers in all of them, all at higher altitudes too, and all ran much better than with the stock D.

Granted, that was the only D needle I tried, but IMO once you rid the WR of all that silliness you should just jet it like a YZ.

In my experience the cam timing (which I tried on one WR) has no effect on the jetting.

Disabling the air cut valve does seem to clear up what can be a little weirdness at lower throttle and idle also, but any serious bog is going to be on your pilot and needle IMO...




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.