Bar Ends

3 replies to this topic
  • BigVthumper

Posted February 25, 2009 - 04:07 PM


Who makes the most rugged set? I need a set bad

  • RedBull420

Posted February 25, 2009 - 04:23 PM


Bar ends?? You speaking of bark busters / handguards??

I use Cycra Probends, very well make and very tough!


Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Sierra_rider

Posted February 26, 2009 - 01:11 AM


If you do mean handguards, I use the cycra probends as well. I like them a lot.

  • Navaho6

Posted February 26, 2009 - 07:45 PM


If it's bar end weights you want, no one makes them for 7/8" aluminum bars except Faast Co. but they are bar inserts and don't work as good as exterior bar ends. I took the bar end weights off my DR650 and drilled the holes larger. Then put a longer bolt through. For handguards, I use Enduro Engineering. The bar end weights greatly reduce handlebar vibrations but add length. I cut my bars down so that the weights put me back to stock length.

Posted Image


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.