Rekluse left hand rear brake and 2 finger clutch with Baja Designs dual sport?


5 replies to this topic
  • davidwaters

Posted February 08, 2009 - 05:23 PM

#1

Anyone successfully used both the Rekluse left hand rear brake/2 finger clutch with the Baja Designs dual sport kit? I just tried and the levers seriously interfere with the switch assembly. Anyone gotten around this?

https://www.bajadesi...switchpanel.jpg

Is there a low profile switch assembly that I could swap in?

  • Krannie McKranface

Posted February 08, 2009 - 05:53 PM

#2

Anyone successfully used both the Rekluse left hand rear brake/2 finger clutch with the Baja Designs dual sport kit? I just tried and the levers seriously interfere with the switch assembly. Anyone gotten around this?

https://www.bajadesi...switchpanel.jpg

Is there a low profile switch assembly that I could swap in?


There are a few lower profile switch clusters (dsa.com), but if you adjust the break (or clutch) lever, you will not need to pull all the way in. That is what I do for my clutch lever, which hits the cluster.

  • davidwaters

Posted February 08, 2009 - 06:00 PM

#3

Could you post a pic of your handlebar setup? I couldn't find a way to get it mounted. I was either going to hit it the switch with the brake lever or clutch lever. The best way I could get it mounted, it would probably kill the bike with a good clutch pull (hit the kill switch).

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Krannie McKranface

Posted February 08, 2009 - 06:56 PM

#4

Could you post a pic of your handlebar setup? I couldn't find a way to get it mounted. I was either going to hit it the switch with the brake lever or clutch lever. The best way I could get it mounted, it would probably kill the bike with a good clutch pull (hit the kill switch).

SURE: HERE YOU GO:
Posted Image
Posted Image
Posted Image
Posted Image

  • davidwaters

Posted February 09, 2009 - 03:29 PM

#5

Oh, I thought you had the Rekluse left hand rear brake and 2 finger override setup. There isn't nearly that much clearance with the new levers that I have... Not even close.

  • Krannie McKranface

Posted February 11, 2009 - 02:51 AM

#6

Oh, I thought you had the Rekluse left hand rear brake and 2 finger override setup. There isn't nearly that much clearance with the new levers that I have... Not even close.


You mean you have a clutch lever and a break lever on the left? Everyone I know that has tried that has taken it off, and gone with either the clutch only or the brake only on the left.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.