01 426 problem


1 reply to this topic
  • glamisrob

Posted January 12, 2009 - 04:19 PM

#1

I recently finished putting a new piston in my 01 426. I also had a valvle work done at my local shop and did the Zip Ty mod to my carb. Carb sat out of the bike a while so new seals and orings were put in. I was already running a Dr D pipe.

The bike is not running well. When I downshift and then hit the gas it sputters until higher RPM is reached, probably from 0-1/8 or 0-1/4 throttle. It does not idle very well either. Also when accelerating in 5th gear it feels like something is slipping and the bike surges. Please help! I am running a 45 pilot jet and a 170 main. Thanks!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted January 13, 2009 - 08:23 PM

#2

Check to be sure that the throttle spring plate on the back of the slide is right side up.





Related Content

Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

Megabomb Fitment by 288yz450


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
Forums
Photo

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride


Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies
Reviews

Yamaha YZ450F 2017 by Chris.GVS


Yamaha YZ450F 2017
  • * * * * *
  • 1 review
  • Last review by Tommyk_55
  • On January 15, 2017
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.