Startet clutch assembly, need help ....


No replies to this topic
  • akiraone

Posted December 15, 2008 - 10:40 AM

#1

Hello,

I’m just finishing of rebuilding my top end (in WR450 06’) , and Im stuck with stupid problem I have some doubt that Im doing it right. Im mean assembling starter clutch. I didn’t remove the starter clutch from the rotor, now when I putted everything together and tightened rotor nut (like in service manual tighten release and retighten) I can move a little bit in and out the starter clutch drive gear ? is it ok ? or Im doing something wrong should I remove the starter clutch from rotor before I assembling everything together or it doesn’t mater ?

I have hope that you know what I want to say  …

And one more should I put some locktite under woodruff key or not.


Regards

Ps. Sorry for English  …..




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.