Exhaust tip any db level you want



1 reply to this topic
  • Littlefoot

Posted July 09, 2002 - 03:15 AM

#1

Following are pics of the exhaust tip I use. The end piece is aluminum machined to fit the stock spark arrestor. The center tube is a piece of 3/4 copper pipe. To meet the appropriate db level sneek up on the level buy drilling holes in the copper pipe. Start off quiet and just keep drilling until reaching the desired level.
I left the boat plug in the picture. I use this when washing to plug the exhaust.

Posted Image
Posted Image
Posted Image
Posted Image

[ July 09, 2002: Message edited by: Littlefoot ]

[ July 09, 2002: Message edited by: Littlefoot ]

[ July 11, 2002: Message edited by: Littlefoot ]

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • BlueFox

Posted July 11, 2002 - 03:48 PM

#2

That looks pretty good. However, one of the big reasons I went to an aftermarket exhaust was for the weight savings. My White Bros E series is quite a bit lighter than stock and wakes the engine up considerably.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.