Rear Swingarm Bearing...


3 replies to this topic
  • Powerage

Posted December 11, 2008 - 12:30 AM

#1

After pulling apart my swingarm and linkage on my '08 450 last weekend to regrease, i found it odd that there no bearing on the back of the engine case where the swingarm pivot shaft goes through... I realise that there are bearings in the swingarm, but would have though a lot of heat and friction would occur on the rod itself at the back of the engine casing?

Just wanted to ask what others think, and can anyone school me on whats going on...

Probably the weirdest thing ive ever asked here, but hell, i wanna know. :thumbsup:

  • husqvarnarider

Posted December 11, 2008 - 03:34 AM

#2

The swing-arm bolt stays stationary in the case and frame, so there's no need for a bearing there.....the motor doesn't move. The swing-arm is the only thing moving.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MaddogYZ

Posted December 11, 2008 - 02:04 PM

#3

I can just invision Powerage doing this right now :thumbsup: haha. It never hurts to ask.

  • Powerage

Posted December 11, 2008 - 10:22 PM

#4

lol... :thumbsup:


:smirk:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.