wr400 swing arm spindle diameter

No replies to this topic
  • sparkie400

Posted December 07, 2008 - 11:13 PM


hello folks, i recently ceased my supermoto 400, a 2001 wr, and have picked up a temp replacement engine whilst i have a rebuild,
on fitting the engine i find that the swing arm spindle will not fit through the collets/bushes in rear of replacement engine!
also the bushes out of the existing motor will not fit into rear of this engine
are there any retro fit bushes to solve this problem available? or will the only option be to get them turned out to fit my spindle



Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.