02 426 and 06 dh1 tripple clamp question

1 reply to this topic
  • 426tahoe

Posted October 13, 2008 - 09:32 AM


so i have an 02 426 and acquired an 06 dh1 tripple clamp with steering stabilizer, or made for an 06 anyway. i know i need 06 or newer forks to fit the tripple clamp but am i going to have a problem with the steering tube or bearings swaping from the emig clamps i have now to the dh1 clamps. also is the dampning pin that attaches to the neck available for the 426? thanks for any help.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted October 13, 2008 - 12:38 PM


What kind of damper is it?

As far as the stem/bearings, *I think* the '06 stem, etc., will fit. You might have to re-work the steering stops though.

Related Content


Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

James Stewart back on a YZ450F by YamaLink

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.