Hot Start Question

No replies to this topic
  • sandman3

Posted September 14, 2008 - 04:52 PM


Has anybody replaced the Hot Start plunger and seal on the FCR Carb. I Have a 06 450, Last night I pulled the plunger to grease the seal and cannot get it back in, I ended up damaging the seal by the time I was done.:lol: :excuseme: :banana: :excuseme: :busted: :busted: It will be a day or so before the new one comes in. I was for sure that it would just drop into place.Any help would be greatly appreciated.

Related Content


Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F

Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.