Ignition Problem! Need help ASAP

1 reply to this topic
  • harwood39

Posted September 01, 2008 - 09:37 AM


Ok guys i am having an ignition issue with my converted YZ426. I have the WR stator and flywheel, it fires right up, but acts like it in neutral all the time with the rev limiter. My Neutral switch is disconected, i disconected the TPS to see if that was the issue, and i just cant figure this one out... I need help ASAP

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted September 01, 2008 - 01:25 PM


Be sure that the light blue lead from the CDI that used to connect to the neutral switch is not grounded at any point. This would give a false neutral signal to the CDI.

Related Content


James Stewart back on a YZ450F by YamaLink

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies

Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

Wilson the Blue Privateer by jetfuel

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.