Gargling hard at 1/2 throttle in 1st & second...


2 replies to this topic
  • bultaco

Posted July 20, 2008 - 06:07 PM

#1

1999 WR400...when accelerating there is seriously interrupted power. Could it be jetting, throttle position sensor....just feel like getting a Eddelbrook carb instead of spending the $$$ to send it to the mechanic. Also...not so easy to start even when going through the correct procedure...just got the bike 2 months ago...any suggestions welcome:excuseme:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Fullbore4

Posted July 20, 2008 - 07:49 PM

#2

Not a good idea to guess and start replacing parts. I'd take the carb off, take it apart and clean and check everything very thoroughly. Accel pump diaphram may need changing for one and AP linkage could be faulty. Float level could be off. Jets or air lines could be plugged. Throttle slide could be cracked. The TPS probably doesn't cause malfunctions like your talking about. Good luck.

  • matt4x4

Posted July 21, 2008 - 09:43 AM

#3

I would clean the carb totally as stated the rough running is likely a dirty carb issue - if it runs good after cleaning but is still hard to start - check valve clearances next.
DO NOT take off or move the TPS - it'll mess things up.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.