Jump to content

brake switch help


Recommended Posts

for the easiest setup .it goes like this : from the battery to a fuse from the fuse to the brake light switch from the brakelight switch to the unused led in the plug of your stock brake light. It is very simple

Link to comment
Share on other sites

It is possible with some wiring and the addition of a brake switch to have the 08 WR rear light also function as a brake light.

The first step is to install a brake switch. My preference is for a hydralic switch that replaces the banjo bolt on the rear master cylinder.

Step Two - If you check the manual's wiring diagram (page 7-1) you will see at the rear light assembly there is a lead that is not used that bypasses the first resistor. This is the YELLOW lead from the light to the connector and there is no lead connected to the other side. ?

I ran a lead from this wire to the brake switch and then ran a return line that I tapped into the positive (GREY) lead feeding the rear light. I have used connectors at the brake switch to allow me to remove the subframe without having to cut the wires and used heat shrink to keep everything waterproof. ?

When I hit the rear brake, VOILA, I have a brake light. ?

Do not attempt this mod if you are electron challenged ?

I had just posted this yesterday in answer to another thread about brake lights.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...