Question on fmf powercore VI

3 replies to this topic
  • dejavudarrell

Posted June 27, 2008 - 05:56 PM


I just bought fmf powercore VI used need some help on install,first thing I notice about pipe is that mid section seems smaller in diameter than stock? and I can't use stock gasket is too big, Is it possible that I bought a fmf powercore for A yz250F?

  • KJ790

Posted June 27, 2008 - 06:03 PM


What year bike are you putting it on? Most aftermarket pipes don't use a gasket at the midpipe joint, most just slip over the header. You can use some high temp silicone to make the seal better if you want.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • dejavudarrell

Posted June 27, 2008 - 07:33 PM


OK, Its a tight fit but its on although stock clamp is to big, and thanks for suggestion on high temp silicone.

  • KJ790

Posted June 27, 2008 - 07:55 PM


You don't use a clamp with a slip fit pipe, just slip it on.

Related Content


Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies

Wilson the Blue Privateer by jetfuel

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.