'08 YZ 450 Valve Check 20 hours


4 replies to this topic
  • MotoXT

Posted June 15, 2008 - 06:38 PM

#1

I've got one intake at .09mm and one exhaust at .19mm, both left side and .01mm under spec. Unfortunately I didn't do a base line check when the bike was new so not sure how much they have moved. I'm thinking about putting 3-5 more hours on it and rechecking to see if they have moved. Any thoughts if this is a bad idea? Bike still starts great, no problems. Thanks.

  • grayracer513

Posted June 15, 2008 - 07:57 PM

#2

.01mm is .0004". Are you really confident that you can measure that small an increment with a feeler gauge?

Even if you are, I think I'd call those .10 and .20 for the time being.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MotoXT

Posted June 16, 2008 - 05:30 AM

#3

.01mm is .0004". Are you really confident that you can measure that small an increment with a feeler gauge?

Even if you are, I think I'd call those .10 and .20 for the time being.


Good point. I'll do a recheck in 5 hours and report back any differences.

Thanks Grey:thumbsup:

  • 02YZ426

Posted June 16, 2008 - 06:02 PM

#4

I just finally got around to checking mine. 100hrs and exactly spec! Gotta love Yamaha!

  • MX926

Posted June 16, 2008 - 06:23 PM

#5

I checked mine on my 08 450 at 25 hrs. My exhasut were perfect, I had two intakes that were tight at 9 and one at 10. Book says 10-15, so I set all my intakes up on the high side, but still in range. Should be good to go for a while.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.