Bent Crank!!!!

1 reply to this topic
  • brent426

Posted May 27, 2008 - 12:09 PM



Bought the 426 and now I am about to throw in the towel. I purchased all new parts, head, valves, piston, cylinder, and the crank was brand new when the motor blew up and ate the top end, I thought it was good but look at the attached http://www.turboimag...IM4712.JPG.html

looks like the small end is a bit cocked. didint like goinging the the cylinder very well. What do you sugest, new crank or just rebuild the crank? Know anyone good to rebuild the crank?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted May 27, 2008 - 12:38 PM


New is better. By the time you add up the parts and the labor for the press work and alignment, it's nearly the same. With the new crank, you get the benefit of a new timing gear, too.

You may want to think about a used engine.

Related Content


2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

James Stewart back on a YZ450F by YamaLink

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies

Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.