Installed Hot-Start Button-No start!

No replies to this topic
  • levy1

Posted May 12, 2002 - 10:48 AM


Yester day I installed a Terry-Cable hot start system on my handlebars. My bikes always starts with 2 kicks when cold and 1 kick with hot-start button out. When hot, I must immediately push the button back in or it will stall. After ridding it for the first time after the install, things changed for some reason. When cold, the bike starts perfect just like before and idles better. After it is hot it is very hard to start. I had to kick it 15 times today and finally gave it a little gas and it fired but 3 times of this in the woods wore me out. Any suggestions?


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.