B&B aluminum case saver (PIC's)

No replies to this topic
  • tk421

Posted November 11, 2002 - 01:24 PM


This is the aluminum case saver by http://www.bbaluminium.com/index.htm .It's much stronger than stock with 4 anchor screws instead of two. Also, the front of the B&B case saver butts up against the outside of the engine case. It's made of quality lightweight aluminum, and has a series of tapered machined holes that give it a trick look. Comes with a bunch of cool decals too.

Two of the four mounting holes had to be elongated slightly with a rat-tailed file before it would fit properly. It was also unfinished with burrs and felt tip marker marks at the offsets.

All in all, a nice looking accessory that adds a bit of piece of mind in the event the chain would break.

Posted Image

Posted Image

Posted Image


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.