2007 XR650R/California model and idle mixture screw!


1 reply to this topic
  • hondacrf150f1

Posted March 31, 2008 - 01:23 PM

#1

Apparently all the 2007 Model XR650R's are the same, so they all had california emmisions....well i removed all the smog crap but there is one small problem.

The idle mixture screw is almost impossible to turn, because its just a flat circle....i think they made it that way so poeple couldnt **** with it. Ive tried sticking a tiny screw driver in there to adjust it, but i marked up the copper pritty bad.

I recently did a side panel venting job and i wanta adjust the jetting and mixture....
thoughts?:prof: ?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • porterdog

Posted April 01, 2008 - 06:03 AM

#2

A guy on ADVrider just did this- I think he plucked the odd screw out and used a dremel to turn it into a normal screw.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.