Stator Gasket

5 replies to this topic
  • Thresher90

Posted March 19, 2008 - 02:07 PM


I am about to rewind my stator and have heard that I might need to buy the gasket that may tear when removing the cover. Does it usually break? I am ordering some other parts and dont want to place two seperate orders.



  • cleonard

Posted March 19, 2008 - 02:35 PM


The way it usually works out is if you don't buy the gasket it will tear, and if you do get one it will be fine. Just buy the gasket to be safe.

  • anaudiophile

Posted March 20, 2008 - 06:31 AM


When I removed mine it stayed intact so perhaps I was lucky!? But it looked like it could easily be siliconed. The surface is very narrow so if you had to remove it again it wouldn't be a big deal. Better than spending 30 bucks or more I think!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • abby

Posted March 20, 2008 - 07:14 AM


I've had mine off three times now and re-used it because it was just fine.

But like cleonard said, I bought one BEFORE I took it off the very first time - otherwise I would have probably had to replace it!

  • Coolidge

Posted March 20, 2008 - 07:27 AM


Get a gasket, 99.5% you'll need it.

  • porterdog

Posted March 20, 2008 - 07:42 AM


1. Get a gasket.
2. RTV the side that goes against the stator cover.
3. Use Hylomar or some other non-hardening sealant on the side that goes against the engine.
4. Never buy another gasket for that bit.

Related Content


Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies

Post Apocalypse, ThumperTalk style! by Justin Pearson

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies

Which thumper motor for a street tracker? by woz

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • * * * * -
  • Hot  29 replies

Fell Off Trailer by usafxr

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies

93 xr650l Restoration Project by Zigster

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.