grey wire


4 replies to this topic
  • longfellow628

Posted March 16, 2008 - 06:53 PM

#1

do I just cut this grey wire? how is everyone doing it

  • firedawg553

Posted March 16, 2008 - 06:56 PM

#2

I have been reading through this forum and others. It is suggested that you take the wire out of the plug with a small screw driver after pulling the plug apart rather than cutting it.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • redswr

Posted March 16, 2008 - 10:17 PM

#3

i just used a small flat head screw driver to push it out of the connector then taped it up...

  • William1

Posted March 17, 2008 - 03:24 AM

#4

I put a switch in the middle of the wire to enable use of both ignition maps.

  • Zsebi-2

Posted March 17, 2008 - 06:47 AM

#5

I put a switch in the middle of the wire to enable use of both ignition maps.


can you switch timing when the bike runs?
I thought I read somewhere that it has to be shut off for it to take effect.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.