2008 Gearing and X-Ring


No replies to this topic
  • malinaric473

Posted March 15, 2008 - 04:20 PM

#1

I just brought home my new 08 450F. I want to put a 53 on the rear and replace the stock chain with a Primary Drive X-ring chain. When I did this on my CRF450, I had to put a washer on the counter shaft to push the sprocket out a little in order to prevent the wider chain from rubbing on the case. I just wanted to make sure that no such thing is needed for the YZ. Also.. If I could get away with going down to a 12 tooth sprocket in the front then I will do that (cheaper). Any comments. I know that the small front sprockets sometimes cause wear issues on the chain and front sprocket.

Thanks in advance...

Tom





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.