New Hand Controls


2 replies to this topic
  • chrama1

Posted March 10, 2008 - 09:38 AM

#1

Hola all... I have a 2007 WR450F and after riding stock for the last two seasons, I have started adding new parts and "modifying" some stock parts.
One of the things that I have replaced were the stock hand controls with ASV F1s. I have everything installed and the brake side works great. THe clutch I have problems with though.
The clutch will engage/disengage with the first half inch of pulling the handle. When riding, I barely squeezed then clutch handle and it went into neutral. I tried to correct this by changing the freeplay adjuster at the lever. The adjuster was already all the way in, so I made adjustments and eventually had it to where the adjuster was all the way out, and I still had the same issue as above.
I guess I need to know if there is another way to adjust the cable at the push lever to make adjustments when the adjuster at the hand control does not do enough?
I appreaciate the feedback.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • chrama1

Posted March 10, 2008 - 03:47 PM

#2

any one? I know someone out there knows.

  • ADVnaut

Posted March 10, 2008 - 03:49 PM

#3

You might be running out of clutch plate.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.